Domotec DSG12 Manuel d'instructions télécharger pdf (Page 17)

Digital Steam Press Instruction Manual

Page15

TROUBLE SHOOTING

Below is a chart detailing the most common problems, their causes and solutions. Before shipping any appliance to a service

center please check to make sure that the solution is not listed here:

PROBLEM CAUSE SOLUTION

Steam Press cannot be opened

using Pressing Handle.

Locking Knob is in Locked position. Turn the Locking Knob to the unlocked

position.

Steam Press becomes warm but

DOES NOT remove wrinkles.

Temperature Setting is not high enough

for the fabric attempted.

Gradually increase the temperature until

obtaining the desired results.

Temperature has not been selected. Make a proper selection.

Press is not plugged into an outlet. Plug the appliance in.

Press DOES NOT get warm.

Automatic Shut-Off has engaged.

The Pressing Plate has been raised for

more than 15 minutes without use.

Press the *POWER* button again.

1 2 ... 12 13 14 15 16 17 18 19

Pas de commentaire

Domotec DSG12 Manuel d'instructions Page 17